Set for modelers, includes:
Fengda AS-18-2 piston, oil-free, single-cylinder compressor with forced cooling and overheating protection.
A reducer with a moisture separator is installed at the output of this compressor, which allows you to regulate the pressure of the air supplied to the airbrush, as well as clean it of moisture, which is extremely undesirable during operation. An automatic pressure regulator is also installed on the compressor, which turns the compressor on/off depending on the air flow.
The low noise level allows the compressor to be used both at home and in other places where relative silence is required. The operating volume of this model is comparable to the operating level of a household refrigerator.
Airbrush with side feed. The capacity is removable with the possibility of attaching it at any angle
both to the right and to the left of the airbrush.
Threaded nozzle 0.2 mm. The needle gasket is Teflon (not afraid of solvents). Paint tank with a volume of 13 ml. The presence of the Air Control regulator allows you to fine-tune the air supply and the width of the drawing line.
